Comment 27 for bug 595650
Revision history for this message
| Till Kamppeter (till-kamppeter) wrote Re: after the last updates printer stopped working | #27 |
© 2004
Canonical Ltd.
•
Terms of use
•
Data privacy
•
Contact Launchpad Support
•
Blog
•
Careers
•
System status
•
0e1f616
(Get the code!)
Walter Garcia-Fontes, you are using the wrong syntax for hp-makeuri. The right way is
hp-makeuri <bus>:<device>, so in your case
hp-makeuri 005:004
Note that bus and device change when you turn off the printer or disconnect it. So run "lsusb" again to get updated bus and device numbers. Important is also that they must enter them with three digits, padded with zeros.
If the command shown above fails, try it also with "sudo", like:
sudo hp-makeuri 005:004